FLOOR PREPARATION FOR NON-SLIP FLOOR PAINTS
Excellent for areas prone to moisture and spillages
Be cautious of using solvent based two pack epoxy over existing floor coatings as solvents may attack the existing paint. If un-sure use solvent free or single pack floor paint.
Two coats of paint are always recommended 1st coat primes and seals the floor. 2nd coat provides good colour build, protection and longevity of the coating.
With any floor coating preparation is an essential key to extend the protection and lifespan of the coating. To prepare a bare (rough) concrete floor prior to painting we always recommend a light abrasion first; this can be done either by a scarifying machine or track blasting (most effective method). This allows the paint to create a good lock and key effect with the concrete which then leads to much better adhesion.
If the floor has been power floated or is generally very shiny, the floor paint will not adhere to this surface. It is recommended to trackblast the concrete to remove most of the top layer prior to painting. The structure of the top layer in a power floated concrete floor is generally unstable and easy to damage this is due to one small partial size been pushed to the top. If trackblasting in not an economical scenario, you can use a scarifying machine or a concentrated Acid Descaler to etch the floor.
After the floor has been abraded, we then recommend degreasing the area, removing dust and anyyd a the floor.ing ical hed to the top layer unstable and easily damaged.
the Christmas holidays they know the pa loose parts. If floors are heavily penetrated with any sort of contamination it is important to remove it all before coating, the most effective way is to have the floor steam cleaned. Remember this will add moisture into the floor, so time will have to be allowed for the moisture to escape. If the floor has light or no contamination just a quick mop around with our Degreasing Solvent or Acid Descaler will suffice. Again ‘preparation’ is key for a good floor coating, should any moisture or contamination be trapped in the substrate the paint will simply blister and blow off.
For the First coat use a the same product as you need in non slip (single pack or two pack) but as a smooth finish this will make it easier to apply the non-slip coating and provide a more even non slip finish.
Use two pack epoxy for all kinds of traffic single pack is more meant for light to medium areas of foot traffic.